[网络-VLAN]思科LAB-划分不同的VLAN，相同VLAN之间互同，不同VLAN之间不通

LAB 目的：

熟练掌握VLAN操作及原理，实现相同VLAN间能ping通，不同VLAN间无法ping通

网络设备类型：cisco switch

拓扑图：

 

网络配置信息：

 

 

 实际应用中的需求：

1）技术部间可以网络互访，技术部与财务部间无法访问

2）只通过二层技术进行不同部门之间网络隔离

3）终端IP地址无网关设置，并配置静态IP地址

具体LAB配置如下：

cisco分布交换机1配置：

 1 Switch>en
 2 Switch#configure 
 3 Configuring from terminal, memory, or network [terminal]? 
 4 Enter configuration commands, one per line.  End with CNTL/Z.
 5 Switch(config)#vlan 10
 6 Switch(config-vlan)#exit
 7 Switch(config)#vlan 20
 8 Switch(config-vlan)#exit
 9 Switch(config)#interface  fastEthernet 0/1
10 Switch(config-if)#switchport mode access 
11 Switch(config-if)#switchport access vlan 10
12 Switch(config-if)#exit
13 Switch(config)#interface  fastEthernet 0/2
14 Switch(config-if)#switchport access vlan 20
15 Switch(config-if)#exit
16 Switch(config)#interface  gigabitEthernet 0/1
17 Switch(config-if)#switchport mode trunk 
18 %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/1, changed state to down
19 
20 %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/1, changed state to up
21 
22 Switch(config-if)#switchport trunk allowed vlan 10
23 Switch(config-if)#exit
24 Switch(config)#exit
25 Switch#
26 %SYS-5-CONFIG_I: Configured from console by console
27 
28 Switch#write
29 Building configuration...
30 [OK]

cisco分布交换机2配置：

 1 Switch>en
 2 Switch#configure 
 3 Configuring from terminal, memory, or network [terminal]? 
 4 Enter configuration commands, one per line.  End with CNTL/Z.
 5 Switch(config)#vlan 10
 6 Switch(config-vlan)#exit
 7 Switch(config)#interface fastEthernet 0/1
 8 Switch(config-if)#switchport access vlan 10
 9 Switch(config-if)#exit
10 Switch(config)#interface gigabitEthernet 0/1
11 Switch(config-if)#switchport mode trunk 
12 Switch(config-if)#switchport trunk allowed vlan 10
13 Switch(config-if)#end
14 %SYS-5-CONFIG_I: Configured from console by console
15 
16 Switch#write
17 Building configuration...
18 [OK]
19 Switch#
20 %LINK-5-CHANGED: Interface FastEthernet0/1, changed state to up
21 
22 %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/1, changed state to up

技术部PC1访问技术部PC2结果如下：

 1 Packet Tracer PC Command Line 1.0
 2 C:\>ping 192.168.10.2
 3 
 4 Pinging 192.168.10.2 with 32 bytes of data:
 5 
 6 Reply from 192.168.10.2: bytes=32 time<1ms TTL=128
 7 Reply from 192.168.10.2: bytes=32 time<1ms TTL=128
 8 Reply from 192.168.10.2: bytes=32 time<1ms TTL=128
 9 Reply from 192.168.10.2: bytes=32 time<1ms TTL=128
10 
11 Ping statistics for 192.168.10.2:
12     Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
13 Approximate round trip times in milli-seconds:
14     Minimum = 0ms, Maximum = 0ms, Average = 0ms

技术部PC1访问财务部PC3结果如下：

 1 C:\>ping 192.168.20.1
 2 
 3 Pinging 192.168.20.1 with 32 bytes of data:
 4 
 5 Request timed out.
 6 Request timed out.
 7 Request timed out.
 8 
 9 Ping statistics for 192.168.20.1:
10     Packets: Sent = 4, Received = 0, Lost = 4 (100% loss),

至此实验已完成

此时再看下每个终端获取的MAC地址及IP地址对应关系缓存信息：

技术部PC1:

1 C:\>arp -a                                                   #所含有技术部PC2的MAC地址信息
2   Internet Address      Physical Address      Type
3   192.168.10.2          0001.967d.b74c        dynamic

技术部PC2:

1 C:\>arp -a
2   Internet Address      Physical Address      Type           #所含有技术部PC1的MAC地址信息
3   192.168.10.1          00e0.8f39.152a        dynamic

财务部PC2:

1 C:\>arp -a                 #没有任何MAC地址信息
2 No ARP Entries Found

 

通过上述实验总结如下：

1）同一vlan可以互访，是在同一个二层广播中，并且通过MAC地址转发数据帧，数据帧封装了上层协议信息（IP地址）

2）二层交换机只工作在数据链路层

 

标签：10,vlan,技术部,VLAN,LAB,Switch,192.168,互同,config
来源： https://www.cnblogs.com/baktomcat/p/15864277.html